Engine Specs - S54 Rod Bolts: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 4: | Line 4: | ||
The S54 has two different types of connecting rod bolts. The torque procedure for each is different. | The S54 has two different types of connecting rod bolts. The torque procedure for each is different. | ||
* Type-1: M11 x 1.25 mm thread pitch. 12 mm bi-hexagonal bolt head. | |||
* Type-2: M10 x 1.25 mm thread pitch. E12 Torx bolt head. | |||
=== OEM Rod Bolts === | === OEM Rod Bolts (M11 x 1.25, 12mm bi-hex bolt head) === | ||
==== SPEC: OEM: Torque procedure ==== | ==== SPEC: OEM: Torque procedure ==== | ||
| Line 13: | Line 15: | ||
!Angle | !Angle | ||
|- | |- | ||
| | |30 Nm | ||
| | |70 degrees | ||
|- | |- | ||
|Remove | |Remove bearing cap | ||
| | | | ||
|- | |- | ||
| | |30 Nm | ||
| | |70 degrees | ||
|- | |- | ||
| | | | ||
|} | |} | ||
<br> | <br> | ||
Revision as of 20:32, 30 January 2016
Rod Bolt Comparisons
The S54 has two different types of connecting rod bolts. The torque procedure for each is different.
- Type-1: M11 x 1.25 mm thread pitch. 12 mm bi-hexagonal bolt head.
- Type-2: M10 x 1.25 mm thread pitch. E12 Torx bolt head.
OEM Rod Bolts (M11 x 1.25, 12mm bi-hex bolt head)
SPEC: OEM: Torque procedure
| Torque | Angle |
|---|---|
| 30 Nm | 70 degrees |
| Remove bearing cap | |
| 30 Nm | 70 degrees |
Make sure you are starting with new rod bolts. Factory rod bolts must be replaced once used.
- Lubricate rod bolt threads and connecting rod cap bore holes with appropriate thread lubricant.
- Torque to 20-Nm, then using a torque-angle gauge tighten another 130-degrees.
- Remove bolts.
- Repeat steps 1-3
- Repeat steps 1, 2.
SPEC: OEM: Clamping Force
- Clamping Force: Approximately 11000 pounds force.