Engine Specs - S54 Connecting Rods: Difference between revisions

From Wiki-DIY
Jump to navigation Jump to search
VisualWikitext
Created page with "__FORCETOC__ == Rod Bolt Comparisons == === OEM Rod Bolts === ==== SPEC: OEM: Torque procedure ==== {| class = "diyTable bearingSpec" !Torque !Angle |- |20 Nm |130 degrees..."
 
Replaced content with "__FORCETOC__ TBD"
 
Line 1: Line 1:
__FORCETOC__
__FORCETOC__


== Rod Bolt Comparisons ==
TBD
=== OEM Rod Bolts ===
 
==== SPEC: OEM: Torque procedure ====
 
{| class = "diyTable bearingSpec"
!Torque
!Angle
|-
|20 Nm
|130 degrees
|-
|Remove
| 
|-
|20 Nm
|130 degrees
|-
|Remove
| 
|-
|20 Nm
|130 degrees
|}
<br>
Make sure you are starting with new rod bolts.  Factory rod bolts must be replaced once used.
# Lubricate rod bolt threads and connecting rod cap bore holes with appropriate thread lubricant.
# Torque to 20-Nm, then using a torque-angle gauge tighten another 130-degrees.
# Remove bolts.
# Repeat steps 1-3
# Repeat steps 1, 2.
<p></p>
 
====SPEC: OEM: Clamping Force====
* '''Clamping Force''':  Approximately 11000 pounds force.
<p></p>

Latest revision as of 20:22, 30 January 2016


TBD

Retrieved from "https://www.wiki-diy.com/index.php?title=Engine_Specs_-_S54_Connecting_Rods&oldid=1263"